Page 2 of 2
Re: PA Piercing
Posted: Wed Sep 19, 2018 12:21 am
by Stefan (imported)
I started with a 3 mm. I was told by the piercer that this has to heal for 3 month. Then you go 1 mm every 6 weeks. For now 5 mm is good for me, but you can go further if you want.
Most important: Be realy sure, about having a PA! The whole for the PA will be there for ever! And I mostly sit down for peeing, but I can at a urinal as well, it's a Little more difficult in case of the second hole.
Re: PA Piercing
Posted: Wed Sep 19, 2018 12:26 am
by unencumbered (imported)
TopManFL (imported) wrote: Tue Sep 18, 2018 11:56 pm
I found this idea for a PA piercing lock online
https://ransommoney.tumblr.com/post/178 ... own-helper
It's not a chastity cage, it's more of a lock that has some support from a cock ring.
My virus checker says the link is safe (then, again, tumblr has good security).
Note: You will have to log into tumblr to see the post. Any yahoo email address and password will do it.
It uses the testicles to secure one end of the rod. It seems to be designed to keep the penis in a constant stretched state.
Re: PA Piercing
Posted: Wed Sep 19, 2018 1:25 am
by TopManFL (imported)
unencumbered (imported) wrote: Wed Sep 19, 2018 12:26 am
It uses the testicles to secure one end of the rod. It seems to be designed to keep the penis in a constant stretched state.
If you use it as an example any of the online manufacturers of piercing and/or chastity devices could make it to order. The support rod on the underside of the penis could be made much shorter or thicker.
The thing I liked about it (for consideration as a lock only / no chastity cage) was its low profile. Also that it adds support to the lock.
That screw you see is the lock. It can be made so that only a special tool will remove the screw. Attempting to use any other tool will strip the head off the screw and make removing the screw very difficult.
Re: PA Piercing
Posted: Wed Sep 19, 2018 8:24 pm
by unencumbered (imported)
TopManFL (imported) wrote: Wed Sep 19, 2018 1:25 am
If you use it as an example any of the online manufacturers of piercing and/or chastity devices could make it to order. The support rod on the underside of the penis could be made much shorter or thicker.
The thing I liked about it (for consideration as a lock only / no chastity cage) was its low profile. Also that it adds support to the lock.
That screw you see is the lock. It can be made so that only a special tool will remove the screw. Attempting to use any other tool will strip the head off the screw and make removing the screw very difficult.
This makes sense. I'll look into it. Thanks!